2. Assembly
The T Frame gantry is supplied in five parts with the gantry base and the
uprights supplied fitted together for ease of transport, to adjust for height
remove the two M10 X 55mm bolts that hold the vertical upright within the T
shaped gantry base.
Adjustment can be made between 2060mm at it’s lowest to a maximum height
of 2380mm,fixing to the desired height is achieved by aligning the M10 X 55
blots to the fixing holes in the uprights of the gantry base and vertical section
bolts are pushed through both sections and secured with a M10 stainless
steel nyloc nut.
Repeat for other side.
Note: Articulating feet at the base of the gantry bases are for allowing
leveling on uneven floor surfaces not for height adjustment
3. Assembling the centre hoist track section
Slide the hoist track pt. no OHTRK1 into the track bracket pt no OHA0123 and
tighten the two grub screws pt. no’s COM1184 using allen key provided to
secure the track into the bracket (see below)
Repeat for other side.
Note: trolley set pt no OHTRK16 should be fitted prior to second bracket
being secured
