Chilli Penguin Penguin 7 Convector, Инструкция по установке и эксплуатации, Страница: 41 / 56

Refuelling on to a low fire bed (not much fuel glowing)
If there is insufficient burning material in the fire bed to light a new load of fuel,
excessive smoke emission can occur. Refuelling must be carried out onto a sufficient
quantity of glowing embers so that the new fuel load will ignite in a reasonable period.
If there are too few embers in the fire bed, add kindling and follow previous steps.
Warning - loading fuel without opening controls can lead to a
sudden ignition and potential damage to your stove and flue system.
WARNINGS
Wood will burn most efficiently when burnt in complete loads – let the fire burn down
to a bed of glowing embers before refuelling the fire box with new logs. Open the
control fully again to get the new fuel burning – once alight re-adjust contols to the
desired position.
REFUELLING
To avoid the risk of excess smoke emission this stove must not be operated with the
door open and the air controls should always be used as directed in the instructions.
Fuel overloading
The maximum amount of fuel specified in this manual should not be exceeded,
overloading can cause excess smoke.
De-ashing
De-ashing is only required periodically as wood burns better on a bed of ash. However
there are some air vents situated within the fuel retainer. Regularly check that ash does
not cover these vents.
Safety
When the stove is in use, always use the glove provided to open the door and the glove
or tool to operate the air control knob.
Your stove has not been designed to run with the door open, it should therefore be
kept shut except when refuelling is carried out.
Air controls
Spares are available through your local Chilli stockist or
our online shop. There are diagrams online to help you
identify the correct parts and advice about how to fit:
www.chillipenguin.co.uk/FAQ/looking-after-your-penguin
Page 38 of 52