pg. 12
SET‐UP CONTINUED
Connecting
the
Power.
Plug the power cord into an outlet.
Note:
This
device
has
a
grounded
plug.
To
reduce
the
risk
of
electric
shock,
this
plug
is
intended
to
fit
in
a
grounded
outlet
only
one
way.
If
it
does
not
fit,
contact
a
qualified
electrician.
Do
not
modify
the
plug
in
any
way.
Filling
the
Cube
with
Water.
Distilled
water
is
recommended
You will need to fill the water reservoir before the first use.
The water reservoir is located on the top center of the Cube.
Unscrew and remove the cap, then add water until the reservoir is full (approximately
14oz/390ml).
Note:
Have
additional
water
ready
to
pour
after
Cube
is
started
to
fill
the
tubing
in
the
Pad.
Turn the Cube on by touching the ON/OFF button.
The Cube will beep and the pump will begin to run (
This
is
where
additional
water
will
be
needed
as
the
water
in
the
reservoir
will
be
pumped
into
the
Pad
).
As water starts circulating through the tubing in your Chili product. Continue to
slowly fill the reservoir until the water level reaches the bottom of the cap thread lines
(this amount will vary depending on the size of your pad).
o
Use clean water.
Distilled
water
is
recommended
.
o
Do not immerse the Cube in water to fill.
o
Be careful not to spill water on the Cube.
o
Refill the water reservoir when the water level gets low or the Low Water light
comes on. The Cube will not operate when the water level in the reservoir is
too low or empty.
Turning
the
Cube
On.
Press the ON/OFF button on the Cube or remote. The Cube will beep and the pump will begin
to run.
Содержание ChiliPAD cube Dual Zone
Страница 1: ...Mooresville North Carolina USER MANUAL...
Страница 10: ...pg 10 USING THE CUBE...
