CHILDHOME ROCKING STAND, Инструкция по эксплуатации

Страница: 2 / 32

2 2
www.childhome.com
ASSEMBLY INSTRUCTIONS
DO NOT allow other children or pets to climb or lean into/onto the basket
when your infant is inside.
The stand is designed for use with a moses basket no more than 32”L x 17”W
Do not add another mattress, lounger, or pillow on top of the mattress provided
or recommended by KLKCM. Co Limited
When not in use, the stand should be stored away from children.
A x 2 B x 2
E x 2
C x 2
F x 2 G x 2
Components
1
50mm
x 20
50mm x 2
50mm x 2
50mm x 2
50mm x 2
IMPORTANT: Please make sure when assembling the stand that the pre-drilled guide holes in each component
are lined up and that the screws are located carefully in the holes before tightening them.
Note: the uprights A and B should curve inwards towards each other with the larger recessed
dowel holes facing the same way.
1. Using 4 x 50mm screws, fasten 1 x A and 1 x B uprights to 1 x base rocker C through the holes in
the base of C. The pre-inserted dowel in A and B will slot into the middle of the 3 holes in C.
2. Repeat with the second set of parts A, B and D.
A
A
B
B
C
C
1 Allen Key
x1
6mm
x 4
D x 2
Im nt: Ensure hol
for iliser in rocker
are g same way a
rec in uprights A
an
DO NOT allow other children or pets to climb or lean into/onto the basket
when your infant is inside.
The stand is designed for use with a moses basket no more than 32”L x 17”W
Do not add another mattress, lounger, or pillow on top of the mattress provided
or recommended by KLKCM. Co Limited
When not in use, the stand should be stored away from children.
A x 2 B x 2
E x 2
C x 2
F x 2 G x 2
Components
1
50mm
x 20
50mm x 2
50mm x 2
50mm x 2
50mm x 2
IMPORTANT: Please make sure when assembling the stand that the pre-drilled guide holes in each component
are lined up and that the screws are located carefully in the holes before tightening them.
Note: the uprights A and B should curve inwards towards each other with the larger recessed
dowel holes facing the same way.
1. Using 4 x 50mm screws, fasten 1 x A and 1 x B uprights to 1 x base rocker C through the holes in
the base of C. The pre-inserted dowel in A and B will slot into the middle of the 3 holes in C.
2. Repeat with the second set of parts A, B and D.
A
A
B
B
C
C
1 Allen Key
x1
6mm
x 4
D x 2
Im nt: Ensure hol
for iliser in rocker
are g same way a
rec in uprights A
an
+-10MIN
1
IMPORTANT: Please make sure when assembling the stand that the pre-drilled guide holes in each
component are lined up and that the screws are located carefully in the holes before tightening them.
Note: the uprights A and B should curve inwards towards each other with the larger recessed dowel holes facing the
same way.
1. Using 4 x 50mm screws, fasten 1 x A and 1 x B uprights to 1 x base rocker C through the holes in the base of C. The
pre-inserted dowel in A and B will slot into the middle of the 3 holes in C.
2. Repeat with the second set of parts A, B and D.