IMPORTANT: RETAIN FOR FUTURE REFERENCE, READ CAREFULLY
ASSEMBLY OPERATING INSTRUCTIONS
HOW TO CARE FOR YOUR CHILDCARE HIGH CHAIR
To assemble legs onto seat...
Harness restraints...
Attaching and removing tray...
Removing harness from seat
for cleaning...
Low chair mode...
Cleaning
Maintenance
To ensure the long-lasting use of your highchair wipe down with a damp cloth and use a mild soap solution if
necessary. Do not use abrasive cleaners. Always store product in a clean dry place.
Always check parts regularly for tightness of screws, nuts and other fasteners – tighten or replace if required. To
maintain the safety of your highchair, seek prompt repairs for bent, torn, worn or broken parts. Use only those
parts and accessories approved by CNP Brands.
If you have any difficulties in assembling the high chair, please contact our Service Department. In Australia, contact
CNP
Brands on 1300 667 137
, in New Zealand contact
Wainhouse Distribution on 0800 567 5000.
Uno
High Chair “White”
Model
# 044289-003
1
1
1
2
2
1
Slide the front top legs with
grooves into the front holes of the
seat, ensuring the grooves align
correctly with internal tab. Depress
spring pin and push leg into seat,
ensuring pin pops into retaining
hole on seat. Repeat for rear legs.
Hook in tray pegs into the
positioning slots as shown in
image. Push tray down until it
firmly clips onto seat. Make sure
tray is secured by grabbing and
lifting tray.
Remove D ring from harness strap
by sliding webbing through the
slot in the D ring as shown.
Push strap end through slot in seat
and remove harness as shown.
Push the four lower leg bars onto
the four top legs by depressing
springpin and pushing each top
leg in. Ensure spring pin pops out
of retaining hole.
Grab the tray on the left or right
in position shown. Whilst holding
chair down, firmly lift and unhook
tray and remove.
Remove the upper legs and insert
4 x lower legs directly into the seat
base.
1a.
To secure child in harness,
push buckle (a) and (b) into
the buckle housing (c) until
the buckle prongs snap into
position.
Carefully adjust the harness
by pulling the slider (d) until
the desired fit is achieved in
the lap, shoulder and crotch
strap.
To release the buckle,
squeeze the top and bottom
prongs until it disengages.
1a.
1b.
1c.
1a.
1a.
1b.
2a.
2a.
1a.
d
d
c
b
a
buckle
prongs
buckle
prongs
slider
slider
buckle
housing
shoulder
straps
CAUTION: The harness
must be used at all
times and be correctly
adjusted - most injuries
from highchairs are
caused by falls.
CAUTION: ALWAYS re-fit harness
after cleaning and before re-use.
