ASSEMBLY / OPERATING INSTRUCTIONS
To install Safety Gate...
1
2
Important: Gate must be installed in a structurally
sound opening.
The hinge side of gate must be mounted to a rigid
surface.
Ensure mounting surface (wall, door frame, stairposts,
etc.) is strong, rigid and has an even surface.
If using gate on a stairway, it must be placed either on
top stair or on lowest stair at the bottom.
1a.
1b.
1c.
2a.
ASSEMBLY / OPERATING INSTRUCTIONS
To install Safety Gate (continued)...
3
4
5
6
6
The correct width will be achieved by adjusting gate
sections and all four corner spindles.
Each spindle adjusts individually and may be
extended varying lengths to allow for moulding,
uneven walls, etc.
Spindles may be extended a minimum of 32mm
(hinge side) or 25mm (on locking side) and a
maximum of 70mm.
Finding appropriate width of gate
Adjust sections until gate is approximately the correct
width and adjustment holes are aligned and overlap
in two places on both the top and bottom rail
(maximum overlap is 5 bars).
Sections should fit without any distance between rails
or bars.
Place screws (I) and screw sockets (J) in top and
bottom sets of overlapping adjustment holes nearest
hinge and locking sides of gate.
Do not fully tighten yet.
Screw upper hinge spindle (H) into top rail of one gate
section.
Screw lower hinge spindle (D) into bottom rail of same
side.
Extend spindles equally.
Screw locking latch spindles (N) into top and
bottom rails of second gate section.
Extend spindles equally.
Final spindle adjustments will be made later.
3a.
3b.
3c.
4a.
4b.
4c.
5a.
5b.
6a.
6b.
6c.
6a.
6b.
6c.
PLEASE NOTE:
Ensure inboard surface gate sections come together before securing
and hardware. This is to eliminate finger hazards between adjacent filler bars.
