ASSEMBLY / OPERATING INSTRUCTIONS
To assemble Swing Frame continued...
To assemble Seat Support to Swing Frame...
To use Restraints / Harness...
c
c
D
D
2
1
2
1
Insert left support tube into the left tube of the main
module with toy arm, ensuring that the label ‘C’ on
each tube aligns as per diagram.
Insert right support tube into the right tube of the main
module with toy arm, ensuring that the label ‘C’ on
each tube aligns as per diagram.
Connect the lower boom tube into the swing tube on
the main module with toy arm.
Ensure that you hear a ‘click’ allowing the pop-pins to
engage securely.
Then use 1x screw (#3) to lock the tubes together as a
secondary locking device.
Place the infant in the seat as show in the diagram.
Insert the left and right sets of buckles into the
restraint latch.
Adjust the straps in the buckles as needed so that
the restraint fits snugly, but not too tightly.
2a.
2b.
1a.
1b.
2a.
1a.
1b.
1c.
PLEASE NOTE!
If the position of the straps needs to be adjusted, it can be
done by threading through the straps from the back of the seat and
threading through a new slot. This should only be practised when infant is not
positioned in the seat. Please ensure that the straps are always level with the
slots they are inserted into.
3
3
