5
D
IRECTIONS
FOR
C
ONVERTING
“C
RIB
”
TO
A
“D
AYBED
”
When use as a crib has been completed, by removing the
Dropside, you have the option to convert to a daybed for years of
additional use in your child’s room. Refer to Step 5 - Diagram 5
and follow directions in reverse order. Store the removed parts
and hardware in the event you wish to convert your daybed back
to a crib. Refer to Sketch A.
WHENEVER DISASSEMBLING YOUR CRIB, DO NOT REMOVE ANY
ITEMS ATTACHED WITH WOOD SCREWS
A
OR
E
!
Sketch A
(style may vary)
MAINTENANCE OF YOUR CHILD CRAFT CRIB/DAYBED: Upon completion of assembly be sure all screws, bolts and fastening devices have been
tightened securely. A frequent check should be made of all screws, bolts and fastening devices and tightened if needed. Before each usage or
assembly, inspect crib for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use crib if parts are missing or broken. Contact
your Dealer or Child Craft (812) 883-3111, for a replacement part or instructional literature if needed. Include Model Identification Number with your
request which you recorded on page 1 of these instructions. DO NOT SUBSTITUTE PARTS. DO NOT MAKE ANY ALTERATIONS NOT DESCRIBED
IN THESE ASSEMBLY DIRECTIONS.
CLEANING INSTRUCTIONS FOR YOUR CHILD CRAFT CRIB/DAYBED: Mix together a mild solution of gentle dishwashing liquid and water, apply to
surface using a soft clean cloth lightly dampened in the solution. Rinse with clear water again using a soft clean cloth, then dry all surfaces thoroughly
with a soft dry cloth. NO ABRASIVE CLEANERS, SCOURING PADS, STEEL WOOL, OR COARSE RAGS SHOULD BE USED TO CLEAN THIS FINE
FURNITURE.
STORAGE AND USE OF YOUR CHILD CRAFT CRIB/DAYBED: A printed plastic pouch is attached to the crib spring for the permanent storage of the
assembly directions. After completing the assembly process you are advised to read and be aware of all WARNINGS, CAUTIONS, CLEANING,
STORAGE, USE AND MAINTENANCE notices contained in this set of directions and printed on the plastic pouch located on the underneath side of the
crib spring. You will then place the complete set of assembly directions into the plastic pouch for future referral. We caution you not to place excess
hardware in the plastic pouch as it could present danger to a child if retrieved. When storing crib use CAUTION as extreme temperature or humidity
changes could be harmful. Use CAUTION when a vaporizer is in use, always aim vapor stream away from crib as well as away from any wood
furniture item.
D
IRECTIONS
FOR
C
ONVERTING
TO
A
F
ULL
S
IZE
H
EADBOARD
Disassemble crib by performing
Steps 5, 4, 3 & 2 in reverse order to
remove the Stationary Side
T
from
the other crib parts. Store assembled
parts carefully for future re-assembly
as a Crib. Attach the Stationary Side
to a Hollywood style full size bed frame
at the location of the mounting cleats
(Hardware is not provided). Insert the
Hole Button Covers
M
as shown.
H00745:11/01
Receiving holes for
Hole Button Covers
M
Receiving holes for
Hole Button Covers
M
Mounting Cleats
(Cleats are flush with the face that the
purchased Hollywood Frame mounts to)
T
X
U
V
Purchased Mattress
(see size requirements on
page 6 under CAUTION)
(style may vary)
(style may vary)
