H04760:03/09
3
When use as a crib has been completed, you have the option to convert your crib to a daybed for years of additional use in your child's
room. Remove one Stationary Side
I
and install Spring
K
in its lowest position. Store removed parts and hardware as perhaps
sometime in the future you may want to convert the daybed
back into a crib. Install Allenhead Bolt
F
and Insert Nut
C
in top hole of each Head/Foot Finish
J
post as
shown. Locate the dowel pins in the ends of Stretcher
L
into their holes in Head/Foot Finishes
J
. Insert
Allenhead Bolts
G
through their holes in Head/Foot
Finish
J
and into Stretcher
L
aligning the threaded
hole in K-D Bolt Plugs
H
. You can use a flat tipped
screwdriver in the slotted end of the K-D Bolt Plug
H
to hold and rotate it to help to align it with the
Allenhead Bolt
G
. Tighten securely. Place Assembly
Directions back into the pouch attached to Spring
K
.
• Again check to be sure each bolt is tightened
securely, then check frequently to be sure all
remain tightened.
Place a purchased mattress on Spring
K
and crib is ready for use.
After completing crib assembly, and after making yourself aware of the
Warnings, Cautions, Cleaning, Storage, Use
and
Maintenance
of crib, store the assembly directions in the pouch which was pre-attached to Spring
K.
For future referral to assembly directions you
will only need to remove them from the pouch. We caution you not to store excess hardware in pouch as this would be a danger to child
if retrieved by him/her.
Check periodically to be sure screws and bolts (fastening devices) remain tight as instructed in step of these assembly directions.
Purchased Mattress
(See size requirements
under
CAUTION
on page 4)
s
teP
3: F
inisHing
t
oUcHes
J
I
J
I
Assembled Crib
(style may vary)
D
AybeD
c
onversion
J
G
J
H
L
C
G
H
L
(post)
(top edge)
J
