Chiko CBA-1500AT3-HC-DSA-V1, Инструкция по эксплуатации

Страница: 44 / 70

Chapter
2Components Identification
42
AT3 Panel
No. Name Function
①
Organic EL
(OLED) display Displays the operating status and various settings.
Displays an error or warning number in case of an error or warning.
②
Suction power
level lamps
Green lamps indicate a suction power level (1 to 7).
③
Up/Down arrow
buttons
During stoppage or operation, switches among the content of the display
“2.4 Display Indications(Page 43)”
In MODE SELECT mode, cycles through parameters and changes
numeric data.
Chapter 4 “Configuring Settings (Page 49)”
④
ERROR lamp
The red lamp lights upon detection of an error that stops device operation.
The red lamp flickers upon detection of an error or warning that continues
device operation
⑤
Left/Right arrow
buttons
During operation, each pressing of the Left (or Right) arrow button
changes the suction power to the next lower (or higher) level.
During MODE SELECT mode, each pressing of the Left (or Right) arrow
button moves the cursor left (or right) to the next position.
⑥
OFF button
Stops the operation.
During stoppage, holding this button down for three seconds clears the
registered initial pressure
“3.3 Registering Initial Pressures(Page 48)”
⑦
ON button Starts operation.
⑧
ENTER button
During operation, holding this button down for three seconds causes
transition to initial pressure registration.
“3.3 Registering Initial Pressures(Page 48)”
During SELECT MODE Mode, determines the selected parameter and its
numeric data
“Chapter 4 Configuring Settings(page 49 ）
⑨
MODE SELECT
button
During stoppage, transits to the MODE SELECT Mode.
“Chapter 4 Configuring Settings(Page 49)”
During MODE SELECT mode, returns to the previous mode. During an
error/warning, transits to the error history mode or error clear mode.
①
②
④
⑥
③
③
⑤
⑦
⑤
⑨
⑧