Chiko CBA-1000AT3-HC-DSA-V1, Инструкция по эксплуатации

Страница: 43 / 70

Chapter 2 Components
Identification
40
2.3
AT3 Panel
No. Name Function
①
Organic EL
(OLED) display
Displays the operating status and various settings.
Displays an error or warning number in case of an error or warning.
②
Suction power
level lamps
Green lamps indicate a suction power level (1 to 7).
③
Up/Down arrow
buttons
During stoppage or operation, switches among the content of the display.
“2.4 Display Indications” (page41)
In MODE SELECT mode, cycles through parameters and changes numeric
data.
“Chapter 4 Configuring Settings
（ MODE SELECT Mode” (page 47)
④
ERROR lamp
The red lamp lights upon detection of an error that stops device operation.
The red lamp flickers upon detection of an error or warning that continues
device operation.
⑤
Left/Right arrow
buttons
During operation, each pressing of the Left (or Right) arrow button changes
the suction power to the next lower (or higher) level.
During MODE SELECT mode, each pressing of the Left (or Right) arrow
button moves the cursor left (or right) to the next position.
⑥
OFF button
Stops the operation.
During stoppage, holding this button down for three seconds clears the
registered initial pressure.
“3.3 Registering Initial Pressures” (page 46)
⑦
ON button Starts operation.
⑧
ENTER button
During operation, holding this button down for three seconds causes
transition to initial pressure registration.
“3.3 Registering Initial Pressures” (page 46)
During SELECT MODE mode, determines the selected parameter and its
numeric data.
“Chapter 4 Configuring Settings
（ MODE SELECT Mode” (page 47)
⑨
MODE SELECT
button
During stoppage, transits to the MODE SELECT mode.
“Chapter 4 Configuring Settings
（ MODE SELECT Mode” (page 47)
①
②
④
⑥
③
③
⑤
⑦
⑤
⑨
⑧