LTAPU
Installation Instructions
6
Figure 4
5.
Drill one 5/16" pilot hole at each marking.
6.
Install an anchor (E1) into each pilot hole using a hammer.
7.
Use two 5/16 x 2-1/2" lag bolts (E2) and two 5/16" flat
washers (E3) to attach top of mount to anchors in wall.
8.
Mark the attachment points for the lower mounting slots.
(See Figure 4)
9.
Drill one pilot hole at each marking for lower mounting
holes. (See Figure 4)
10. Install an anchor (E1) into each pilot hole using a hammer.
11. Use two 5/16 x 2-1/2" lag bolts (E2) and two 5/16" flat
washers (E3) to attach the mount to the wall through the
lower mounting holes. (See Figure 4)
12. Slide rails to approximate center of screen location.
Attaching Display Brackets to Display
1.
Horizontally align the center of the display brackets (D) with
center of screen. (See Figure 5)
NOTE:
The notch in the top and bottom of the display bracket
(D) corresponds to the center of the bracket.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display. Properly sized
screws will easily and completely thread into display
mounting holes. If spacers are required, be sure to use longer
screws of the same diameter.
Figure 5
2.
Select correct screws, spacers (if necessary) and washers
from the hardware bag and attach display brackets (D) to
back of screen. (See Figure 5)
Attaching Uprights to Display Brackets
1.
Vertically align the center of the uprights (B and C) with
center of screen. (See Figure 6)
NOTE:
The diamond-shape opening in the uprights (B and C)
corresponds to the vertical center of the upright.
2.
Attach uprights (B and C) to the display brackets (D) on the
display back using eight 5/16" x 1/2" button head cap
screws (F2) and eight 5/16" flat washers (F1).
(See Figure 6)
IMPORTANT ! :
Attach uprights with four screws per
display bracket (D), two at each end. If possible, attach
the uprights with one screw in a top hole and one
diagonally located in a lower hole on each end of the
display bracket. (See Figure 7) At the minimum, one
screw should be in a top hole, and one in a bottom hole
at each end of the display bracket.
7 11
(E2) x 4
(E3) x 4
8
5
6
4
9
x4
(E1) x 4
10
Center of
Bracket
(G13 or G14)
(G12)
(G1 through G11)
(D)
Display
