CHIEF Wall Mount PDWP MB 46 L, Инструкция по эксплуатации

Страница: 8 / 24

LSA/LTA Series Installation Instructions
8
Switching Interface Brackets (Optional)
If an installation situation makes adjusting the location of
interface brackets necessary, there are several options.
1.
The wall brackets may be adjusted side to side at the point
of attachment. (See Figure 5)
2. The location of the left and right interface brackets may be
switched, with the knobs on the LTA interface brackets
facing the inside of the mount. (See Figure 5)
Figure 5
3. If necessary, the tilt interface bracket knobs may be
switched to allow the interface brackets to be reversed.
(See Figure 6)
a. Remove display from mount.
b. Remove interface brackets from display.
c. Hold the right interface bracket horizontally, tightly
gripping it so that spacers do not move.
d. Remove the knob, washer and screw.
e. Replace the knob, washer and screw in the opposite
order, with the knob on the inside of the bracket.
f. Switch the right interface bracket to the left side of the
wall mount.
g. Repeat Steps 3c through 3f with the left interface
bracket.
Figure 6
Attaching Screen to Wall Mount
1. Adjust Velcro® pull strap (if necessary) so it does not extend
beyond bottom of screen. (See Figure 7)
NOTE:
Do NOT allow both interface brackets to be located on
same side of wall bracket. (See Figure 7)
NOTE:
NEVER place both interface brackets to one side of the
wall mount center line! (See Figure 7)
1
2
Knobs
3d
3e
Knobs to outside
of brackets