CHIEF SMART-LIFT SL151i, Руководство по установке

Страница: 6 / 28

SL151i Installation Instructions
6
IMPORTANT ! :
This product must be grounded. If it should
malfunction or break down, grounding provides a path of least
resistance for electric current to reduce the risk of electric
shock.
Grounding Instructions
This product is equipped with a test cord having an equipment-
grounding conductor and a grounding plug. The plug must be
plugged into an appropriate outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
WARNING:
RISK OF ELECTROCUTION! All electrical
wiring required for installation should be installed by a
qualified electrician.
WARNING:
PINCH HAZARD! FINGERS OR HANDS
BETWEEN MOVING PARTS CAN LEAD TO SEVERE
PERSONAL INJURY! Keep fingers and hands away from
mount when operating.
7. Press the push button to test the SL151i while it is still in the
pre-test position.
•
Press when the lift is at its extended position and it will
retract.
• Press when the lift is at its retracted position and it will
extend.
• Press while the lift is moving and it will stop.
• Leave SL151i in the open position.
Removing Ceiling Panel
1. Remove and save screws attaching guide wires to ceiling
panel. (See Figure 5)
Figure 5
2. Lift up on each corner of ceiling panel to remove panel from
clips. (See Figure 6) and (See Figure 7)
Figure 6
Figure 7
INSTALLING IN CEILING
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
LIFT FALLING CAUSING SEVERE PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installers responsibility
to make certain the structure to which the lift is being
mounted is capable of supporting five times the weight of the
lift and all attached equipment. Reinforce the structure as
required before installing the lift.
The following instructions assume a suitable mounting structure
and surface exists prior to installation and all power and signal
wires and cables have been properly installed.
Installing in a Suspended Ceiling
NOTE:
The SL151i may be suspended from three 3/8 in.
diameter x 8 in. length (minimum) Grade 2 or better
threaded rods (not provided) which are secured to a
1-5/8" x 1-5/8" 12ga metal framing channel (spanning a
maximum of 5 feet--not provided) by Grade 2 or better
3/8" channel nuts (not provided).
Guide Wire
(one on each side)
Remove
Screw
(one on
each side)
Ceiling
Panel
Guide
Wire
Ceiling
Panel
Clip
Ceiling Panel Removed