Service Manual
SL220-SK2
5
Replacing Motor Assembly
1.
Remove four screws from panel to left of motor assembly.
(See Figure 9)
2.
Carefully pull out panel (it is attached to the ground wire),
and move it away from motor assembly.
3.
Disconnect motor cable from control (behind panel). (See
Figure 9)
Figure 9
4.
Remove one flat head screw and screw bushing from each
end of motor assembly. (See Figure 9)
5.
Set motor assembly to side. (See Figure 9)
6.
Remove five screws from motor bracket, and move bracket
enough to remove motor cable from under bracket notches.
(See Figure 10)
Figure 10
7.
Liberally spread grease (D) onto motor assembly (A) shaft
using included brush (H). (See Figure 11)
CAUTION:
Grease may stain fabrics.
8.
Add lifting nut (E) to motor assembly (A) by turning it onto
the motor assembly shaft. (See Figure 11)
Figure 11
9.
Route motor cable attached to new motor assembly (A)
under notches at bottom of motor bracket. (See Figure 12)
10. Replace five screws (removed in Step 6) into motor bracket,
ensuring that motor cable is routed under
BOTH
brackets at
bottom of motor bracket. (See Figure 12)
Figure 12
1
x 4
2
Motor cable
3
Motor assembly
Panel
4
5
x 2
Screw
bushings
Motor
bracket
6
Motor
cable
x 5
Apply
grease
7
(A)
(E)
8
Motor
bracket
10
Motor
cable
9
x 5
(A)
