Page 2 of 3
2.
Remove screws securing table stand to display and remove table stand from display (see Figure 4 and
Figure 5.
NOTE: If installing display on Chief Mount without subwoofer, proceed to step # 6 (Page 3).
CAUTION! The Chief PDS, PDR, PNR and PLP mounts require the display
to be installed without the subwoofer.
3.
Remove four socket head screws, using M4 Allen key supplied, and subwoofer from table stand.
4.
Secure subwoofer to back of display by sliding uprights into holes in display (see Figure 6 &
Figure 7).
5.
Attach side bracket to back of display by stacking spacers and using M5 screws (see Figure 8 &
Figure 9). Make sure to use the four M5 x 90mm screws in lower holes, two M5 x 80mm screws in
middle holes and two M5 x 75mm screws in upper holes.
Proceed to step 8 (page 3).
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
