Installation Instructions
POTR-XL / ROTR-XL
5
ASSEMBLY
NOTE:
Proceed to Step 2 if assembling Models POTR-XL/
ROTR-XL8,-9,-10 or -11.
1.
Attach rack rails (D) to POTR-XL/ROTR-XL using three
1/4-20 x 1/2" pem studs (C) and three 1/4-20 lock nuts (B) for
each rack rail. (See Figure 1)
NOTE:
Leave the hardware loose until all three fasteners on
one rack rail have been installed, then tighten.
Figure 1
2.
Remove and SAVE two screws from POTR-XL/ROTR-XL
front and remove the cover plate. (See Figure 2)
Figure 2
3.
Attach POTR-XL/ROTR-XL base to floor of cabinet or to a
pedestal or stand using 1/4-20 bolts (not included) through
the base. (See Figure 3)
4.
The POTR-XL/ROTR-XL may now slide back and forth on
the base.
5.
If installing a POTR-XL, proceed to
Completing
Installation
section.
Figure 3
ROTR-XL Only
1.
Unlock the thumbscrew in the ROTR-XL front. (See Figure 4)
2.
Pull out and swivel the ROTR-XL as needed to gain access
to the back.
3.
Swivel ROTR-XL to front and tighten thumbscrew to keep
from swiveling. (See Figure 4)
Figure 4
1
(B) x 6
(C) x 6
(D)
(ROTR-XL shown as example)
2
x 2
Cover plate
(ROTR-XL shown as example)
Mounting
holes
Mounting
holes
3
3
3
3
1
2