Installation Instructions
PLP Series
6
ATTACH PSB TO THE DISPLAY
To attach the PSB to the display, do the following:
•
To help your identify the correct PSB that matches
the model number of your display, refer to the cross-
reference chart at
www.chiefmfg.com
.
•
To download the corresponding PSB installation
instructions, refer to
www.chiefmfg.com
.
OR
•
Contact Customer Service at 952-582-6480 if you
have any questions about how to select the PSB that
matches the model number of your display.
INSTALL THE DISPLAY
To install the display, do the following:
NOTE:
Verify that all
power/audio/video cables
are
disconnected from the display and the latching
flag is lowered in the down position before
attempting to mount the display.
1.
With the aid of another person, lift the display up to
the mount on the wall, aligning mounting buttons
with the teardrop slots on the mount, and lower the
display firmly into place (Figure 8).
2.
Raise the latching flag to secure the display (see
Figure 9). If the flag does not fully engage, check to
ensure the mounting buttons are fully seated in the
slots.
NOTE:
A padlock may be installed through the hole in
the latching flag for additional security.
REMOVE THE DISPLAY
To remove the display from the mount, do the following:
1.
Disconnect all power/audio/video cables.
2.
Lower the latching flag to unlock the display (refer to
Figure 9).
3.
With the aid of another person, lift the display up and
out of the teardrop slots in the mount to remove the
display.
Figure 8. Install the Display
Figure 9. Raise Latching Flag to Lock
Lock
Unlock
Latching
Flag
Teardrop Slot
PLP
Display
PSB
