CHIEF MANUFACTURING INC.
8805-000141 (Rev. C)
1-800-582-6480
952-894-6280 FAX 952-894-6918
©
2005 Chief Manufacturing
8401 EAGLE CREEK PARKWAY, STE. 700
www.chiefmfg.com
SAVAGE, MINNESOTA 55378 USA 11/05
I N S T A L L A T I O N I N S T R U C T I O N S
PLP Series
Wall Mount
The PLP Series wall mount accommodates large flat
screens weighing up to 200 lbs (90.72kg). The teardrop
holes in the mount allow for quick connect/disconnect of
the screen, thus simplifying installation and maintenance
processes.
The top and bottom mounting brackets are adaptable to
supporting framework with wood studs that are 16” on
center or 24”on center.
The mount has integrated lateral shift, allowing for four
different mounting options. For dual wood studs 16” on
center, the lateral shift is
+
4.5 inches. For dual wood
studs 24” on center, the lateral shift is
+
0.5 inches.
The display can be pulled and tilted by hand into any
position in the zero-to-15 degree tilt range and remain
stationary.
The bottom of the mount pulls forward 3” from the wall
and locks into place for installation of cable connections.
The mount also uses Chief’s exclusive Q-Latch™
mounting system, which offers quick connect/disconnect
display mounting. The display is secured to the mount
with a latching flag. For additional security, you can lock
the latching flag in place by adding a padlock.
PLP Series
! IMPORTANT:
If the installation of this product requires OSHPD seismic
approval, refer to OSHPD pre-approval
documents and drawings before beginning installation. OSHPD documents and drawings are available at
www.chiefmfg.com
, and located on the product information page for the mount.
BEFORE YOU BEGIN
•
CAUTION: To prevent damage to your monitor and PLP, which could affect or void the Factory warranty,
thoroughly study all instructions and illustrations before you begin to install the mount. Pay particular
attention to the Warnings and Cautions in this document.
•
The mount is designed to be installed using wall studs or supporting framework. The fasteners used to anchor the
mount must be capable of supporting five times the total weight of the equipment.
•
The maximum weight to be installed on the PLP Series wall mount is 200 lbs (90.72kg).
•
If you have any questions about this installation, contact Chief Manufacturing at 1-800-582-6480 or 952-582-6480.
