PIT BOSS
Users Manual
8
Shop-Hopper Removable Casters
The removable casters of the Shop-Hopper give three
primary benefits. First, they allow the Shop-Hopper to be
docked with the Fuzion at both ends. Second, they allow
the Fuzion to be lowered into the lowest position with the
Shop-Hopper docked. Third, they allow the Shop-Hopper to
sit on the floor when removed.
Removable Caster Mounting
The removable casters can be mounted from the ends and
from the sides at both ends of the Shop-Hopper. For normal
use all casters should always be mounted from the sides for
maximum stability. Mounting one pair from the end and the
other pair from the side allows the Shop-Hopper to be
docked with the Fuzion.
WARNING:
To prevent personal injury or
property damage never mount both
pairs of casters from the ends of the
Shop-Hopper. (See figure 13)
To remove the casters the Shop-Hopper must first be raised
at least 4 inches. Next, lock the swivel lock mechanism on
the caster to be removed. Third, remove the hair pin clip
from the retaining pin. (See figure 10) Then slightly lift the
caster end of the mount and remove the pin at the same
time. With the pin removed the mount will pivot down. (See
figure 11) Continue to pivot the mount down and unhook
the mount from the lock. The mount will then slide freely
from the Shop-Hopper. (See figure 12)
To install the casters, the Shop-Hopper must be lifted at
least 16” off the floor. Installation is similar to removal with
some additional steps. First, determine the most likely use
of the Shop-Hopper. If it is to be docked with the Fuzion,
pick which end will be to the front of the Fuzion. That end
will have to have the casters mounted from the end. If the
Shop-Hopper is not likely to be docked, all casters should be
mounted from the side for maximum stability. (See figure 13)
After this has been done, the casters can be installed at the
appropriate locations.
Figure 13
Figure 10
Figure 11
Figure 12
WARNING
To prevent personal injury and property damage. Always
fully engage the pin and hair pin clip when installing the
casters.
