Installation Instructions
OLCB2X1U
11
6.
If necessary, loosen button head tilt friction bolt (located on
side of interface bracket). (See Figure 12)
7.
Adjust tilt as required. (See Figure 12)
8.
The tilt may be locked at -7.6°, -5°, 0°, 5°, 10°, 15° and 20°
using one 1/4-20 x 2" Phillips head screw (N), one 1/4-20
lock nut (Q) and two 1/4" washers (T) per interface bracket.
(See Figure 11) and (See Figure 12)
NOTE:
Use of washers (T) is optional.
9.
Tighten button head tilt friction bolt as necessary.
Figure 12
Level Adjustment
1.
Adjust level adjustment screws to change roll position.The
roll may be adjusted 1" in either direction. (See Figure 13)
Figure 13
Latch Lock/Security
IMPORTANT ! :
In order to prevent interface latch from
getting loose due to strong winds, the latch MUST be
locked either using a padlock or locking bolt (N) and 5/
16-18 hex nuts (Q). This is NOT optional!
Using Padlocks (Security)
1.
Add padlock (not included) to each interface bracket to lock
latch and to provide security for displays. (See Figure 14)
Figure 14
Using Bolts/Nuts
NOTE:
This will keep latch from opening but does not provide
additional security for the displays.
1.
Use 5/16-18 x 2" hex head carriage bolt (P), 5/16-18 hex nut
(R) and two 5/16" washers (S) to lock each interface bracket
latch in place. (See Figure 15)
Figure 15
Tilt
friction
bolt
4
4
7
(Displays not shown)
6
(N)
(Q)
0° tilt
20° tilt
5
(T) x 2
level adjustment screws
or
Padlock
(Optional)
(OLCM1U shown)
(P)
(R)
(S) x 2