CHIEF LWM2X1UP, Руководство по установке

Страница: 7 / 20

Installation Instructions LWM2X1UP / LWM3X1UP
7
7. Rotate wall assembly so that height-adjust screw is at top of
wall upright assembly. (See Figure 6)
8. Insert one shoulder washer and one steel washer between
outer bracket and wall upright assembly in four locations.
9. Insert wall upright assembly into outer bracket by placing
wall upright assembly onto threaded pem at top of outer
bracket.
Figure 6
10. Fasten one button head screw, spring washer and flat
washer into four locations on sides of wall upright.
11. Fasten hex head screw into bottom of wall upright.
12. Replace and tighten flanged nut and washer onto threaded
pem at top of wall upright. (See Figure 6)
Attach Wall Uprights
IMPORTANT ! : Reference Wall Placement Information
section (See Figure 1) and Table 1.
1. Use the outside wall upright (CC) as a model to mark upper
pilot hole placement for 2 outside wall uprights following wall
placement information in Figure 1 and Table 1. (See Figure 7)
Figure 7
IMPORTANT ! : See Parts drawing, Table 2 and
Installing to Wood Stud Walls or Installing to
Concrete Walls section for details on installing wall
brackets into wood studs or concrete.
Table 2: Fastener Information
7
9
9
Height-adjust
screw
Threaded pem
8
Shoulder washer
Steel washer
Outer bracket
10
x 4
Spring
washer
Flat
washer
12
11
WALL
TYPE
PILOT
HOLE
FASTENERS (see PARTS
drawing)
Wood stud
(2" x 4") 7/32" x 3" 5/16 x 2-3/4" hex head lag (Y) &
5/16" slotted washer (AA) .
Fasteners placed at stud
locations . Refer to Table 1 for
proper spacing for each model.
Concrete 3/8" x 3" 5/16 x 2-3/4" hex head lag (Y) &
Fischer UX10x60 anchor (Z).
Refer to Table 1 for proper
spacing for each model.
1
(CC)