CHIEF LTTU, Руководство по установке, Страница: 8 / 12

LTTU Installation Instructions
8
3. Determine which screws to use to connect interface
brackets to display. Use the screws that fit into the holes on
the back of the display. Make sure screws can make at least
three full turns into mounting holes. If not, select longer
screw from hardware kit.
4. Determine which washers and shoulder washers to use with
the corresponding screw. Refer to table below for details.
5. Install four button head cap screws (E-Q) through required
washers (R) and spacers (S or T), interface brackets (B and
C), spacers (U or V) and into holes on back of display. (See
Figure 4)
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT. Displays can weigh in
excess of 40 lbs (18.1 kg). ALWAYS use two people and
proper lifting techniques when installing display.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the LTTU up to (and
including) the display does not exceed 100 lbs (45.4 kg).
NOTE:
Make sure locking flags are in the open position before
attaching display to wall plate. Flags are shown in the
open position in Figure 4.
NOTE:
Display can be adjusted horizontally as long as guide
hooks are securely attached to wall plate.
6. While supporting both sides of display, lift display up to the
wall plate on the wall.
7. Slowly guide hooks on top of interface brackets on top of
wall plate in desired mounting location. (See Figure 5)
8. Slowly swing display toward wall. (See Figure 5)
Figure 5
9. Rotate flags on each interface bracket down to the closed
position in order to lock brackets to wall plate. (See Figure
6)
NOTE:
Flags should stay in locked position unless removing
display from wall bracket.
NOTE:
Display should be held in full vertical position by spring
clips on uprights. For some larger displays, a second
spring clip (DD) may be required in order to hold the
display in the full vertical position. See "Extra Spring
Clip Installation" Section for details.
Figure 6
Screw Size Washers Shoulder Washers
M4 use R use S
M5 use R use S
M6 none use T
M8 none none
7
8
WALL
9 x 2
(A)
locking flag