CHIEF LCM2X2, Руководство по установке

Страница: 6 / 20

LCM Video Wall Series Installation Instructions
6
Installing Interface Brackets to Displays
1. Place displays face down on a soft, non-abrasive surface.
IMPORTANT ! : Screen width information is contained in
the Dimension drawings at the end of these instructions.
CAUTION:
Using screws of improper diameter may
damage your display! Proper screws will easily thread into
display mounting holes.
2. Select screw diameter by examining hardware (A-C and F-H)
(6mm or 8mm) and comparing with mounting holes on
display. (See Figure 3)
3. Select spacers:
• Spacers are NOT required if mounting holes are
not recessed and interface brackets (L and M)
can lay flat against display.
• Spacers (E) ARE required if mounting holes are
recessed, or if protrusions prevent interface
brackets (L and M) from laying flat.
CAUTION:
Using screws of improper length may damage
your display! Proper screws will have adequate thread
engagement without contacting bottom of display mounting
holes.
4. Select screw length: (See Figure 3)
• By hand, insert SHORTEST length screw of
selected diameter (A or F) through 1/4" washer
(D), bracket (L or M), selected spacer (E, if
required), into display mounting hole. Do NOT
thread screw into hole at this time.
• Proper screw length requires base of screw head
to protrude above flat washer a
distance equal to
or greater than the screw diameter. If screw
length is inadequate, select longer screw. Select
shortest screw which will protrude the required
distance.
5. Make sure diamond on interface brackets is even with
center of display. (See Figure 3)
6. Use selected screws (A-C or F-H), washers (D) and spacers
(E), if necessary, to connect interface brackets (L and M) to
back of display. (See Figure 3)
Figure 3
(E) x 4, if required
(M)
(L)
(A-C or F-H) x 4
5
(D) x 4
Match diamond with
center of display