CHIEF K1C250, Руководство по установке, Страница: 8 / 12

K1C250 Installation Instructions
8
Pivot Adjustment Range
1. Adjust arm angles as desired within a 90 degree range from
the edge and a perpendicular centerline of mount. (See
Figure 8)
Figure 8
Portrait Adjustment
1. The monitor may be adjusted 90 degrees in either direction
in order to provide a portrait view of the monitor.
(See Figure 9)
Figure 9
WARNING:
Only remove display from mount when the
display can be lifted up from the mount! DO NOT remove
display unless the display is in the upright position! See
Display Removal section for details.
Cable Management
1. Use screwdriver to unhinge tab on either end of cable
management cover on upper arm. (See Figure 10)
2. Slide screwdriver along edge of cover until remaining tabs
are unhinged and cover is in the "open" position. (See
Figure 10) and (See Figure 11)
Figure 10
Figure 11
3. Route cables through cable management channel. (See
Figure 11)
IMPORTANT ! : Be sure to leave enough slack in the
cables near display and arm joint to allow for full arm
articulation!
4. Close cable management cover on monitor arm. (See
Figure 11)
5. Repeat Steps 1-4 for the other mounting arm.
perpendicular centerline
90 degrees range
of motion per arm
edge of desk
(top view)
cable management cover
1
2
2
4
3
cable (typical)