iC-PFM3 Series
Installation Instructions
14
INSTALL BRACKETS TO DISPLAY
WARNING:
The minimum hole pattern size is
100mm x 100mm for the iCMPFM3 and 200mm x
200mm for the iCLPFM3 and the iCXPFM3.
1.
Lay display face down on protective surface.
CAUTION:
Using screws of improper diameter
may damage your display! Proper screws will easily
thread into display mounting holes.
2.
Select screw
diameter
by examining hardware
(C-S) (8mm, 6mm, 5mm, or 4mm) and comparing
with mounting holes on display.
3.
Select spacers:
•
If mounting holes are not recessed and both
brackets (B) can lay flat against display, then
no spacers are required.
•
If mounting holes are recessed, or if
protrusions prevent brackets (B) from laying
flat, then spacers (T or U) must be used.
Select shortest spacer which will provide
adequate fill. All spacers must be same
length.
CAUTION:
Using screws of improper length may
damage your display! Proper screws will have
adequate thread engagement without contacting
bottom of display mounting holes.
4.
Select screw
length:
•
Using your hand, insert SHORTEST length
screw of selected diameter (C, G, K or P)
through bracket (B), universal washer (V),
selected spacer (T or U, if required), into
display mounting hole. Do NOT thread screw
into hole at this time.
•
Proper screw length requires base of screw
head to protrude above flat washer a
distance
equal to or greater than the screw diameter.
If screw length is inadequate, select longer
screw. Select
shortest
screw which will
protrude the required distance.
5.
Place brackets (B) on display, ensuring:
•
Upper hooks are towards
top
of display.
•
Center of brackets (B) are as close to the
center of the back of display as possible after
being installed. Center of bracket is indicated
by the diamond-shaped hole.
6.
Using Phillips screwdriver, carefully install
selected screws through universal washers (V),
brackets (B), and spacers (T or U, if required), into
display.
7.
Tighten all screws. Ensure all applicable display
mounting holes (4, 6, or 8) are used.
2
(V) x 4, x 6, x 8
2
4
6
(C-S) x4,x6,x8
(V) x4,x6,x8
5
6
(C-S) x 4,x 6,x 8
2
4
3
(T or U)
5
(non-recessed holes)
(recessed holes)
(B) x 2
(B) x 2
