Installation Instructions
FSRI2T
5
7.
Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 5)
8.
Repeat Steps 4 through 7 for each mounting hole.
Figure 5
9.
Place FSRI2T over anchors and align mounting holes in
FSRI2T with holes in anchors. (See Figure 1)
10. Insert 1/4-20 x 1-3/4" Phillips pan head screw (C) through
1/4" washer (D), corresponding mounting hole on FSRI2T
and into toggler anchor (E) and tighten until flush against
mount. DO NOT overtighten! (See Figure 1)
11. Repeat Steps 10 and 11 for remaining 3 mounting holes.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Overtightening of
mounting hardware can damage the steel studs. DO NOT
overtighten mounting hardware!
Figure 6
Installing to Concrete Wall
1.
Determine mounting location on wall.
2.
Using FSRI2T as a template, level and mark four holes at
the four holes in FSRI2T. (See Figure 7)
3.
Drill four 1/4" pilot holes at marked locations on wall. (See
Figure 7)
4.
Install four 1/4-20 x 1-3/4" Phillips pan head screws (C)
through four 1/4" washers (D), holes in FSRI2T and into four
pilot holes. (See Figure 7)
Figure 7
Installing iPad
®
2 or 3
1.
Remove two 06-32 x 1/4" buttonhead security screws from
one end of the FSRI2T. (See Figure 8)
2.
Remove one end of FSRI2T. (See Figure 8)
Figure 8
Plastic Straps
Drywall
Anchor Metal Channel
Plastic Cap
7
(side view)
Drywall
Anchor Metal Channel
(FSRI2T)
(C) x 4
10
(D) x 4
(side view)
2
3
x 4
4
(D) x 4
(C) x 4
FSRI2T
1
2
(F) x 2
Содержание FSRI2T
Страница 7: ...Installation Instructions FSRI2T 7 ...
