Drywall Installation Procedures:
Minimum Sheetrock Thickness ½ Inch.
2.
Using the wall bracket as a template at the desired mounting location, mark the location of the four
outer mounting holes.
3.
Using a 3/8-inch drill, drill four pilot holes
to a minimum depth of 1 1/2”
at the locations marked
in Step 2.
4.
Install an anchor bolt in one of the pilot holes and tighten anchor bolt until it is fully seated (see
Figure 3).
5.
Remove and retain bolt and washer from anchor and repeat Step 4 and 5 for three remaining anchor
bolts.
6.
Using four bolts, with washers installed, secure wall bracket to wall.
Wood Stud Installation Procedures:
1.
Locate stud and, using wall bracket as a template at the desired height, mark the location of the two
center mounting holes.
2.
Install a .25 ID x .06 OD flat washer on each of the two wood screws.
3.
Using the two wood screws with flat washers installed, secure wall bracket to wall.
Mounting Display with Interface Bracket to Wall Bracket:
1.
Make sure the latching flag on the mounting bracket is in the unlocked position (see Figure 4).
2.
Place your small flat panel display; with interface bracket attached, onto the wall bracket, making
sure it is securely seated.
3.
Lower the latching flag on the wall bracket, locking small flat panel display in place (see Figure 5).
Figure 5
CAUTION!
Outer Mounting Holes
Figure 4
Locked
Unlocked
%%c
0.375 (PREDRILL HOLE)
INSERT ANCHOR INTOPPREDRILLED HOLE
CW
ANCHOR BARBP(STOPS ANCHOR ROTATION)
#10-24 Screw
Anchor
O
0.375 (Predrill Hole)
Insert anchor into
predrilled hole
Anchor Barb
(Stops anchor rotation)
Turn 10-24 screw clockwise
until anchor fully seats
against back side of wall
CW
Figure 3
Inner Mounting Holes
