CHIEF Flexlink KXD220, Руководство по установке

Страница: 7 / 12

Installation Instructions KXD220
7
Using Grommet Hardware
1. Remove desk clamp from mount by loosening button head
cap screw until clamp is completely disengaged from the
bolt. (See Figure 5)
2. Maneuver clamp so that it is totally removed from desk
mount. (See Figure 5)
NOTE:
Set removed washers aside for re-use.
Figure 5
3. Locate a flat surface (thickness of 3/4” minimum to 3 1/2”
maximum) on which to mount the desk mount plate.
4. If mounting hole does not already exist on desk, drill 3/8”
mounting hole in desk at desired mounting location.
IMPORTANT ! : Mounting hole must be between 3/8”
and 2 1/2” in diameter!
5. Place mount on desk over grommet hole. (See Figure 6)
6. Use 5/16-18 x 6” button head cap screw (G), removed
washers, clamp bracket (E) and 5/16-18” square nut (F) to
secure mount to desk. (See Figure 6)
Figure 6
Display Installation - Standard Faceplate
1. Remove quick release faceplate from mount by pulling
quick release lever and sliding faceplate off mount. (See
Figure 7)
Figure 7
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components and accessories attached to the KXD220
Monitor Arm up to (and including) the display does not
exceed 25 lbs (11.34 kg) per display or 50 lbs (22.68 kg) total.
2. Carefully place display face down on protective surface.
3. Connect faceplate to display
For flush mounting hole installation:
• Using Phillips screwdriver, carefully install four
M4x10mm screws (B) through corresponding
holes on faceplate and into the mounting holes on
the display. (See Figure 8)
Figure 8
2
1
removed
washers
(E)
(F)
(G)
6
removed washers
quick release lever
1
1
(for flush mounting holes)
(B) x 4
quick release
faceplate
3