CHIEF FCA810V, Руководство по установке

Страница: 7 / 20

Installation Instructions FCA810V/VE
7
ASSEMBLY AND INSTALLATION
Below Installation
NOTE:
FCA810V/VE camera mounts may be installed above
or below displays. To install above display, proceed to
“Above Installation” Section.
Assembling Camera Mount to Upright Bracket
1. Attach camera housing (Z) to camera mount (F) using two
#8-32 x 3/8” Phillips flat head machine screws (AA). (See
Figure 1)
IMPORTANT ! : Make sure straight slot on camera
housing is pointing in the proper direction. (See Figure 1)
Figure 1
2. (Standard to cart/ceiling) Use three 1/4-20 x 1/2” button
head cap screws (L) and two large washers (P) to secure
camera mount (F) to upright bracket (A). (See Figure 2)
Figure 2
3. (Standard to wall) Use two 1/4-20 x 1/2” button head cap
screws (L), two large washers (P) and one 1/4-20 x 1/4"
button head cap screw (R) to secure camera mount (F) to
upright bracket (A). (See Figure 3)
Figure 3
NOTE:
If camera must be offset to one side or the other, attach
camera mount (F) to upright bracket (A) as shown in
Steps 4 and 5.
4. (Offset) Use two 1/4-20 x 1/2” button head cap screws (L)
and two large washers (P) to secure horizontal bracket (G)
to upright bracket (A). (See Figure 4)
5. (Offset) Use two #10-24 lock nuts (J), two small washers
(K) and two round head carriage bolts (E) to secure camera
mount (F) to horizontal bracket (G). (See Figure 4)
Figure 4
(AA) x 2
(Z)
(F)
1
straight slot
(L) x 3
2
2
(P) x 2
(F)
(A)
(Standard - to Cart/Ceiling)
(L) x 2
3
3
(P) x 2
(F)
(A)
(Standard - to Wall)
(R)
3
(L) x 2
4
(P) x 2
(F)
(A)
(E) x 2
5
(J) x 2
(K) x 2
(Offset - to Cart/Ceiling)
(Offset - to Wall)
(L) x 2
4
(P) x 2
(F)
(A)
(E) x 2
5 (J) x 2
(K) x 2
(G)
(G)