Installation Instructions
CTA-100
9
STEP 5 (OPTIONAL)
Figure 9. Install Second Attachment Plate
Stacking Two Units
Stack two units, as follows:
1. Locate the top attachment plate (10) for the second
unit.
CAUTION
The stacked load cannot exceed 50lbs. (22.7kg).
2. Install the second attachment plate (10) on the center
plate (20) of the first CTA-100 unit. Use four flat
washers (70) and four M5 X 8mm button head cap
screws (60). Tighten the screws. See Figure 9.
3. Attach the second CTA-100 to the second attachment
plate (10). Use four flat washers (70), four M5 X 8mm
button head cap screws (60). Tighten the screws.
4. Install your VCR/DVD into the CTA-100.
5. Adjust the side plates (30) and adjustment plates (40)
as needed to secure your VCR/DVD safely in the
CTA-100.
6. Tighten all cap screws (60).
WARNING
Failure to install and tighten the screws to secure your
VCR/DVD can result in personal injury and/or
equipment damage.
7. Check the CTA-100 to ensure that the side plates (30)
and adjustment plates (40) are adjusted correctly. The
unit should fit tightly around your VCR/DVD. If not,
repeat steps 5 and 6 until your VCR/DVD is secure.
Stacking Three Units
Stack three units, as follows:
1. Perform the “Stacking Two Units” procedure to install
the third CTA-100.
CAUTION
Do not stack more than three VCR/DVD mounts from
a TV/Monitor mount. The stacked load cannot exceed
50lbs. (22.7kg).
2. Verify that all three units are secure.
CONNECT SECOND ATTACHMENT PLATE
TO BOTTOM CENTER PLATE OF CTA-100.
(70)
(80)
(10)
