CHIEF Air Jack, Руководство пользователя

Страница: 4 / 8

CHIEF AIR JACK
USERS MANUAL
The Chief AirJack (see Figure 1) is a lightweight lifting
tool that is easy to use. The device is ideal for tire and
alignment shops, body shops, and service garages that fre-
quently need to elevate the front end, rear end or side of
a vehicle for tire removal / installation.
Read all of the instructions and warnings provided before
attempting to operate the Chief Air Jack. Also, make sure
all personnel who are to use the Chief Air Jack are familiar
with its operation.
To operate the Chief air jack:
1. Position vehicle on solid flat surface and engage its
parking brake.
2. Block vehicles front and rear wheels.
3. Attach air hose to air jack and position jack on solid flat
surface directly below structural component to be lifted.
NOTE: • Air inlet on control base handle accepts 1/4
inch NPT fitting. (See Figure 2.) Add a
few drops of pneumatic tool oil to air inlet
monthly.
• Position handle assembly for easy access.
WARNING! DO NOT remove brass plug from
handle assembly.
4. Check the intended lifting point on the structural compo-
nent. This location must be parallel with base of air jack
and lift pad. (See Figure 3.) If it is not parallel (see Figure
4), the load may drop suddenly, creating a potential for
severe injury or death.
WARNING! To prevent slippage, lifting point on
structural component must always be parallel
with base of air jack and lift pad.
Figure 2
Figure 1
Figure 3
Figure 4
1
WARNING!
• Visually inspect air jack prior to each use.
DO NOT use if scars, abrasions, rips,
punctures are detected in the air bag.
• Always wear safety glasses.
• DO NOT use as a jack stand.
• Avoid contact with petroleum based
products or chemicals of any kind.
• Use jack stand on firm level surfaces only.
• Avoid sharp objects that may puncture
air bag.
• DO NOT use near open flame, sparks, or
temperatures exceeding 120° F (49° C).
• Maximum air pressure, 105 PSI (7.24 Bar) .
• Maximum load, 2 ton (1800 kg.)
Handle
Assembly
Base
Lift Pad
Top Plate
Air Inlet
Brass Plug
Lifting Point On Structural Component
Base
Parallel
Alignment
Lift
Pad
Lifting Point On Structural Component
Base
Non
Alignment
Lift
Pad