CHIEF 841872159935, Руководство по установке

Страница: 6 / 12

K0 Series Installation Instructions
6
Assembly And Installation
Figure 1
(F) x 2
(E)
(G) x 2
3
4
5
set screw 6
side view
Connecting K0W Series (wall mount) to Wall
1. Determine mounting location on wall.
2. Use a stud finder to locate 2" x 4" wood stud.
3. Use wall bracket (E) to mark and drill two 1/8 x 2 1/2” holes
in wall at desired mounting location. (See Figure 1)
4. Use two 1/4-2 1/2” hex head lag screws (F) and two 1/4”
washers (G) to install wall bracket (E) onto wall. (See
Figure 1)
IMPORTANT ! : Over tightening screws (F) may cause
bracket to compress into soft wall surface resulting in
difficult mount installation or improper engaging of set
screw in Step 6.
5. Hang monitor arm (A) over wall bracket (E). (See Figure 1)
6. Secure monitor arm to wall bracket (E) by tightening set
screw. Ensure set screw engages back side of wall bracket
(E) to properly secure mount. (See Figure 1)
Connecting K0P Series to Pole
1. Determine approximate location for mount keeping in mind
display size, extension, height adjustment requirements.
2. Place mount (A) against pole with clamp (H) on opposite
side of pole. (See Figure 2)
Figure 2
3. Using 5/32” hex key (L) and appropriate length screws,
loosely attach K0P assembly to pole clamp (H). If installing
to 1 1/2” NPT pipe, use 1/4-20 x 1 1/2” button head cap
screws (J). If installing to 1 1/2” diameter pipe, use 1/4-20 x
1" button head cap screws (K). (See Figure 2)
4. Position mount at desired height and orientation.
5. Equally tighten screws against mount and the pole clamp.
3 (J or K) x 4
(H)
K0P assembly