SKU 46319
Page 3
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur.
It must be understood by the operator that common sense and caution are
factors which cannot be built into this product, but must be supplied by the
operator.
Unpacking
When unpacking, check to make sure all parts listed on Page 4 are included. If
any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.
Assembly
NOTE:
You will need a crescent wrench to assemble this product.
1.
Place the Tool Tray (E) on a flat level surface.
2. Insert the large end of the Lifting Pole (D) into the round opening in the
center of the Tool Tray.
3. Place the Seat (A) over the top end of the Lifting Pole (D).
See page 4,
Assembly Drawing and Parts List.
Operation/Maintenance/Additional Safety Warnings
With its convenient tool tray, comfortable padded seat, and non-marking
1.
wheels, the Pneumatic Roller Seat is essential for the multi-tasking crafts
person.
To lower seat, sit on the Stool and pull up on the handle until you have
2.
lowered the seat to the desired height (See Diagram I on Page 4). To raise
seat, stand next to the Stool and pull up on the handle. Release handle when
seat has risen to the desired height.
Operate on a smooth, level floor capable of supporting the seat’s capacity.
3.
Do not let children play on or around the Roller Seat.
4.
Do not stand on Roller Seat or use the tool tray to carry large amounts of
5.
weight. Do not attempt to exceed the Roller Seat’s 300 lb capacity.
Once assembled, do not attempt to take this product apart.
6.
Do not expose to heat. Parts of this product are under pressure.
7.
Always hold onto seat as you sit down to keep the seat from rolling or tipping.
8.
REV 07f, 09h
