Page 4
SKU 38391
For technical questions, please call 1-800-444-3353.
damaged should be carefully checked to determine that it will operate
properly and perform its intended function. Do not use the tool if any switch
does not turn On and Off properly.
22.
Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty.
23.
Do not operate tool if under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgment or reflexes are
impaired while taking drugs. If there is any doubt, do not operate the tool.
24.
Caution: Lead acid batteries generate additional hydrogen gases during
charging operations. Hydrogen gas is poisonous to breath, highly flammable
and explosive. Only use the Jumpstarter System in a well ventilated area.
No smoking allowed in the working area.
Warning: People with pacemakers should consult their physician(s) before using
this product. Operation of electrical equipment in close proximity to a heart
pacemaker could cause interference or failure of the pacemaker.
Operation
Warning: Electrical shock can cause death or injury.
Avoid touching exposed conductors of electricity.
The Jumpstarter System is designed for use with vehicles and boats. You will not
need a host vehicle or 120 VAC power supply. You can also use this system as a
portable power source of 12 VDC in remote areas or emergencies.
To use the Jumpstarter System to start your vehicle:
1. Make sure the vehicle or boat to be jump started is not running. Make sure the
safety switch on the jumpstarter is in the OFF position.
2. Connect the black cable to the negative body ground.
3. Connect the red cable to the positive terminal on the vehicle’s battery.
4. Switch the vehicle or boat ignition to the On position, and the safety switch on
the jumpstarter to the ON position.
5. Wait for about a minute or two.
6. Switch the boat or vehicle to the start position for no more than 5 to 6
seconds.
7. If the vehicle or boat engine does not start, wait at least 3 minutes before
retrying.
Caution: Never allow the red and black clamps to touch
each other or a common conductor.
REv 02/00; REv 04/06; REv 08a
