Page 4
SKU 09631
Note
: Performance of this tool may vary depending on variations in local line voltage. Exten-
sion cord usage may also affect tool performance.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure that all the parts are included. Refer to the Parts List
and Assembly Photo at the end of this manual. If any parts are missing or broken, please
call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
Assembly
1.
Use Screws (3), Washers (4), and Locking Nuts (5) to assemble all Stand frame
components.
2.
Assemble a Lower Side Cross Frame (8) to two Lower Legs (6) and two Upper Legs
(2). See left photo below.
The Upper Leg (2) mounts over the Lower Leg (6). There are two sets of mounting
holes on the Lower Leg depending on the desired Stand height. Refer to the
Assembly Photo for an overall assembly view.
3.
Repeat step 2 for the opposite side.
4.
Attach the front and rear Lower Cross Frames (7) to the inside of the Lower Legs (6).
5.
Attach the rear Top Cross Frame (10) to the outside of the Upper Legs (2).
6.
Mount the front Top Cross Frame (10), with Table Top (1), to the Upper Legs (2).
7.
Mount the 10 Inch Compound Slide Miter Saw to the Stand Table Top using Bolts (11),
Lock Washer (12), Large Washer (13), and Nut (14) in four places. Refer to the photo
on the next page.
(8)
(6)
(6)
(2)
(2)
(3), (4)
(4), (5)
(7)
(10)
(7)
(1)
SIDE VIEW
REAR VIEW
Brought to You by Augusta Flint
