Chicago Pneumatic CPG 90-120 JD, Инструкция по эксплуатации

Страница: 33 / 56

- 33 -
Topping up of coolant
– Verify if the engine cooling system is in a good
condition (no leaks, clean,...).
– Check the condition of the coolant.
– If the condition of the coolant is outside the limits,
the complete coolant should be replaced (see
section “Replacing the coolant”).
– Always top-up with GENCOOL EG.
– Topping up the coolant with water only, changes
the concentration of additives and is therefore not
allowed.
Replacing the coolant
Drain
– Completely drain the entire cooling system.
– Used coolant must be disposed or recycled in
accordance with laws and local regulations.
Flush
– Flush twice with clean water. Used coolant must
be disposed or recycled in accordance with laws
and local regulations.
– From the Chicago Pneumatic Instruction book,
determine the amount of GENCOOL EG required
and pour into the radiator top tank.
– It should be clearly understood that the risk for
contamination is reduced in case of proper
cleaning.
– In case a certain content of ‘other’ coolant remains
in the system, the coolant with the lowest
properties influences the quality of the ‘mixed’
coolant.
Fill
– To assure proper operation and the release of
trapped air, run the engine until normal engine
operation temperature is reached. Turn off the
engine and allow to cool.
– Recheck coolant level and add if necessary.
Storage of the generator
Storage
– Store the generator in a dry, frost-free room which
is well ventilated.
– Run the engine regularly, e.g. once a week, until it
is warmed up. If this is impossible, extra
precautions must be taken:
• Consult the engine’s operator manual.
• Remove the battery. Store it in a dry, frost-free
room. Keep the battery clean and its terminals
lightly covered with petroleum jelly. Recharge
the battery regularly.
• Clean the generator and protect all electrical
components against moisture.
• Place silica gel bags, VCI paper (Volatile
Corrosion Inhibitor) or another drying agent
inside the generator and close the doors.
• Stick sheets of VCI paper with adhesive tape
on the bodywork to close off all openings.
• Wrap the generator, except the bottom, with a
plastic bag.
In case of a mix of different coolant
products this type of measurement
might provide incorrect values.