Page 9
SKU 95912
for technical questions, please call 1-800-444-3353.
REV 07c, 08k
“POWER IN”
“POWER OuT”
REMOTE TRANsMITTER
(23)
fIguRE d
WIRE CABLE
(22)
fREEWHEEL kNOB
(1)
(dIsENgAgEd)
CLEVIs HOOk
(22)
HOOk sTRAP
(24)
fIguRE C
6.
Point the Remote Transmitter (23) toward the Winch, and press the
“POWER OuT”
button on the Transmitter. Then pull out the Wire Cable to the desired length. Make
sure to leave at least five turns of Wire Cable on the Drum (5) to prevent pulling
the Cable completely out of the Winch.
Note:
Once the
POWER OuT
button is
released, the winch will continue to release a few additional feet of cable; this is
normal operation for this type of product.
(see figure d.)
CLEVIs HOOk
(22)
fIguRE E
7.
Remove the Hook Strap (24), and hook the Clevis Hook (22) onto the object using
a pulling point, tow strap, or chain (none included). Make sure the Safety Latch on
the Clevis Hook is properly in place. Never wrap the Wire Cable (22) around the
object or hook onto the object itself. This can cause damage to the object being
pulled and/or kink or fray the Wire Cable.
(see figure E.)
Engage the Freewheel Knob (1) on the Winch by turning the Knob to the
8.
“IN”
position.
(see figure f.)
9.
WARNINg!
Never allow anyone to stand near the Wire Cable (22), or in line
with the Cable behind the Winch while it is under power. Should the Cable slip or
