SKU 95380
For technical questions, please call 1-800-444-3353
PAGE 5
SPECIFIC SAFETY RULES
1.
Maintain labels and nameplates on the Router and its Table.
These carry important information. If unreadable or missing,
contact Harbor Freight Tools for a replacement.
2.
Avoid unintentional starting.
Make sure you are prepared
to begin work before turning on the Router.
3.
Do not force the Router.
This tool will do the work better and
safer at the speed and capacity for which it was designed.
4.
This Router is designed for use only with 1/2” Router Bits and
3/8” and 1/4” Adapters rated at 20,000 RPM or greater.
5.
WARNING! Keep hands and fingers away from the cutting area and
Router Bit
(not included)
.
Use a “push stick” (not included) when necessary.
6.
Make sure the Router Table is securely attached to a dry,
flat, level, sturdy workbench surface capable of supporting
the weight of the unit, accessories, and workpieces.
7.
Never leave the Router Table unattended when it is plugged into an
electrical outlet.
Always unplug the unit from its electrical outlet before leaving.
8.
Industrial applications must follow OSHA guidelines.
9.
Never stand on the Router Table.
Serious injury could result if the unit is tipped.
10.
Always unplug the Router Table from its power supply source before
performing any inspection, maintenance, or cleaning procedures.
11.
Keep all guards in place and in proper working order.
12.
Allow the Router Bit
(not included)
to spin up to full speed before feeding
a workpiece into the Bit.
When turning off the Router, allow the Bit to
spin down and stop on its own. Do not press against the Bit to stop it.
13.
Turn off the Router and allow the Router Bit
(not included)
to stop on
its own if the workpiece is to be backed out of an uncompleted cut.
14.
Never attempt to remove material stuck in the moving parts
of the Router while it is plugged in and running.
15.
When routing a large workpiece, make sure its entire length is properly
supported.
If necessary, use a roller stand (not included) with larger workpieces.
16.
Never attempt to cut freehand.
Make sure the workpiece
to be cut is pressed firmly against the Table’s Fence.
