Page 12
SKUs 94596 &
94896
for technical questions, please call 1-800-444-3353.
UNpACkINg
When unpacking, check to make sure all the parts shown on the
parts list on page
16
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
pROdUCT fEATURES
SIdE HANdlE
lUbRICATINg
UNIT kNOb
WAx TUbE
UppER gUARd
lOWER gUARd
HOUSINg
pOWER SWITCH
pOWER
CORd/plUg
fIgURE E
power Switch:
The Power Switch is a simple “slider” switch that when pressed
and held turns on the Twin Cutter Saw. To turn off the Saw, release pressure on the
Power Switch and the switch will automatically return up to its “OFF” position.
power Cord/plug:
The Power Cord/Plug must only be connected to a 120 volt,
grounded, electrical outlet. Do not pull on the Cord to remove the Plug from its
electrical outlet.
Side Handle and Housing:
The Side Handle allows for increased control of the
Twin Cutter Saw and additional safety. When using the Saw, always maintain a firm
grip on the Side Handle
and
Housing.
lower guard and Upper guard:
Before each use of the Twin Cutter Saw, always
check to make sure the Lower Guard and Upper Guard are operating properly. Also,
make sure the Saw Blades do not touch either Guard.
Wax Tube and lubricating Unit knob:
Always use a lubricating Wax Tube when
cutting aluminum, copper, stainless steel, and cast iron. When cutting, these materi-
als tend to soften and adhere to the Saw Blades and can diminish the performance
of the Twin Cutter Saw. To use a Wax Tube, insert the Wax Tube into the Lubricat-
ing Unit Dispenser. Turn the Lubricating Unit Knob to apply lubricant to the Saw
1.
2.
3.
4.
5.
