Page 11
SKU 94362
For technical questions, please call 1-800-444-3353.
20.
Always use Saw Blades with the correct size and shape (diamond
vs. round) arbor holes.
Saw Blades that do not match the mounting hardware
of the Saw will run eccentrically, causing loss of control.
21.
Never use damaged or incorrect Saw Blade (part #10) Inner/Outer Flanges
(9, 11) or Screw (15).
The Inner and Outer Flanges and Screw were specially
designed for this Saw, for optimum performance and safety of operation.
22.
Feed the Saw gradually into the workpiece.
Do not attempt to force the Saw
to remove material faster than it was designed to cut.
23.
Secure the workpiece.
Whenever possible, secure the workpiece with a vise or
clamps (not included).
24.
Make sure to remove all adjusting wrenches and tools before turning on
the Saw.
28.
Do not allow children to use or play with this product.
29.
Store idle equipment.
When not in use, tools and equipment should be stored
in a dry location to inhibit rust. Always lock up tools and equipment, and keep out
of reach of children.
30.
Do not use this product if under the influence of alcohol or drugs.
Read
warning labels on prescriptions to determine if your judgement or reflexes are
impaired while taking drugs. If there is any doubt, do not attempt to use this
product.
25.
Do not force the Saw.
This tool will do the work better and safer at the speed
and capacity for which it was designed.
26.
Never leave the Saw unattended when it is plugged into an electrical
outlet.
Turn off the tool, and unplug it from its electrical outlet before leaving.
27.
Reduce the risk of accidental starting.
Make sure the Trigger Switch (66) is in
the
“OFF”
position before plugging the Power Cord (71) into a 120 volt, grounded,
electrical outlet.
31.
Dress properly.
Do not wear loose clothing or jewelry as they can be caught in
moving parts. Wear restrictive hair covering to contain long hair.
32.
Do not overreach.
Keep proper footing and balance at all times. Do not reach
over or across running machines.
33.
Industrial applications must follow OSHA requirements.
