SKU 93366
Page 4
Replacing the Battery:
When the Battery (8) is dead, it can be easily replaced. To replace the Battery,
take out the screw on the back of the lamp, slide off Battery Cover (9) and pull out the Battery. Remove red
and black wire connections from the old battery. Attach these two wire connections to the new replacement
battery.
Note:
Make sure red battery wire connects to red battery terminal and black battery wire connects to black
battery terminal. Carefully slide the new Battery into Battery Box (7 & 11), making sure that the wires are
not damaged. Slide Battery Cover (9) back into place.
REPLACING THE BULB
WARNING:
Always wear ANSI approved safety goggles and work gloves when replacing the bulb.
1) Gently pull off the Black PVC Cover.
NOTE:
When putting the cover back on, make sure it is put in the correct position so it fits perfectly on the
housing.
2) Remove the 2 Plastic Glass Holders (18 & 24).
NOTE:
When putting plastic Glass Holders back in place, make
sure the groove on each holder is properly aligned with the housing.
FIGURE 1
COVER OF BATTERY (9)
RED CHARGING LIGHT
TRIGGER LOCK (19)
TRIPOD ADAPTER (21)
Pull
Pull
3) Carefully remove the Glass (2).
4) Pull out the Reflector (3).
5) Remove the pin on the back of the Reflector, and take out
the bulb assembly.
6) To replace the bulb, pull the two bulb wire leads away from
the connecting wires. Do not attempt to pull on the bulb to
remove it; the bulb may break causing personal injury.
7) Connect the two wire leads of the new bulb to the
connecting wires of the Spotlight. Put the bulb back into the
reflector and lock the bulb in place by securing with the pin.
8) Carefully put the glass back in place, and secure with the 2
Plastic Glass Holders. Make sure groove on each holder is
properly aligned with the housing.
9) Fit the Black PVC cover back in place.
