Page 8
For technical questions, please call 1-800-444-3353.
SKU 92880
SpECIFICATIOnS
Construction
High-Impact Plastic
Housing, Brass Spindle &
Collets, Stainless Chuck
Body
Power Required
9.6 VDC / NiCd Battery
Pack
Battery Recharge
120 VAC to 12 VDC
Transformer
Tool Speed
Variable:
5,000 - 25,000 RPM
LED Source
(2) CR-927 3 VDC batteries
Features
Variable Speed,
LED Light Attachment
unpacking
When unpacking, make sure that the item is
intact and undamaged. If any parts are missing or
broken, please call Harbor Freight Tools at 1-800-
444-3353 as soon as possible.
When unpacking, check to make sure the
following parts are included:
9.6V Rotary Tool w/Battery
Shaft Mounted LED Light Attachment
AC/DC Transformer
9.6V Battery Charger Base
3-piece Cutoff Wheel Set
4-Piece Sanding Drum Set
36-Piece Sanding Disc Set
2-Piece Buffing Wheel Set
2-Piece Brass Collet Set
2-Piece Drill Bit Set
10-Piece Mounted Stone Set
2-Piece Diamond Burr Set
Flat Wrench
Square Stone Dresser
Plastic Carrying Case
Charging the Battery pack
Battery packs are normally shipped with
low or no charge to prevent potential
problems during shipment. Before use,
you must charge your new battery pack.
Figure 2
note:
Batteries will not reach full charge the
first time they are charged. Allow several
cycles (operation followed by recharging)
before the battery will become fully charged.
WARnIng:
Battery explosion may cause
serious personal or property injury including
death. Charge the battery only within a 50° to
100° temperature range. Lower temperatures
may inhibit charging. Higher temperatures
increase chance of battery failure, including
explosion.
Charge the battery pack only with the
1.
included Charger Base (25). Use of
other chargers may cause battery failure
including explosion.
Ensure that the Charger Base (25) is
2.
connected to a circuit breaker protected
120 VAC, 60 Hz power supply only.
Connect the Charger Base to the
3.
Transformer (24), by plugging it in as
shown in Figure 2. Plug the Transformer
(24) into a 120 VAC wall outlet.
REV 10e
Figure 1
