Page 11
For technical questions, please call 1-800-444-3353.
Item 68829
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Tool Set Up - Blade Installation / Replacement
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its
electrical outlet before adjusting tool or installing accessories.
1. Loosen the Table Knob and remove the Table.
2. Use two wrenches (sold separately)
to remove the Arbor Nut:
one wrench to hold the Spindle Nut and
another wrench to loosen the Arbor Nut.
3. Slide a Blade Shim onto the spindle, then
a Blade (with the Blade’s arrow matching the
label’s arrow), and the other Blade Shim.
4. Replace the Arbor nut and
wrench tighten it securely.
5.
WARNING! To prevent serious injury,
replace the Table after service and secure
firmly in place using the Table Knob.
Arbor
Nut
Spindle
Nut
Blade
Figure B: Blade Installation
Workpiece and Work Area Set Up
1. Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
2. Route the power cord along a safe route
to reach the work area without creating a
tripping hazard or exposing the power cord
to possible damage. The power cord must
reach the work area with enough extra length
to allow free movement while working.
3. Secure loose workpieces using a
vise or clamps (not included) to
prevent movement while working.
4. There must not be objects, such as
utility lines, nearby that will present
a hazard while working.
General Operating Instructions
1. Plug in the Power Cord.
2. Lift the Guard and slide the Straight Edge
Guide out far enough to allow you to lay your
workpiece flat on the Table. Lower the Guard
onto your workpiece.
Do not remove the
Guard or attempt to operate this tool
without either Guard in place.
3. Flip the Power Switch on.
4. Using the Straight Edge Guide to hold
your workpiece steady, gently feed your
workpiece toward the Blade. Keep your
fingers away from the Blade at all times.
WARNING!
If the workpiece is small, use
another small piece of wood or other material
to push workpiece toward the Blade.
Note:
Do not push forcefully against the Blade, or
use materials that are particularly difficult to cut.
If the Blade slows down, you are pushing
too forcefully, or the material is too
hard or thick for this tool to cut.
5. To prevent accidents, turn off the
tool and disconnect its power supply
after use. Clean, then store the tool
indoors out of children’s reach.
Содержание 68829
Страница 1: ......
