Page 7
For technical questions, please call 1-800-444-3353.
SKU 68303
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY
INFORMATION section at the beginning
of this manual including all text
under subheadings therein before
set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and
unplug the tool from its electrical outlet before
adjusting tool or installing accessories.
Assembly
1. Turn the Power Switch off and unplug the tool.
2. Place the attachment over the Spindle, shoulder
facing away from the tool. Line up the holes on the
attachment with the pins on the Spindle shoulder.
Angled Cutter
Note:
The Angled Cutter Blade should only be used in the
straight ahead position and not an angled position.
3.
Place Large
Washer,
cupped side down
Slide the Small Washer, then the Large Washer
onto the the Cap Screw. Make sure the cupped
side of the Large Washer is toward the tool.
While holding the attachment over the pins on
the tool, thread the Cap Screw in place.
4. Tighten the cap screw onto the Spindle
using the provided Hex Key.
Torque
firmly (approximately 10 ft-lb).
5. After securing, the attachment should not move on
the spindle. If it can move with the power off,
remount it, making sure that the holes on the
attachment line up with the pins on the spindle.
Tighten the cap screw securely.
Torque to 10 ft-lb
