Page 6
For technical questions, please call 1-888-866-5797.
Item 68221
SAFET
y
Op
ERA
TION
M
AINTENANCE
SETU
p
Setup - Before Use:
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURy FROM ACCIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its electrical outlet
before performing any procedure in this section.
Note:
For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Mounting
Note:
The Sharpener must be mounted
on a horizontal surface.
1. Position the Sharpener on the mounting
surface so that the mounting stop butts up
against the vertical edge of the surface.
2. Using the Base as a template, mark
locations of mounting holes.
3. Drill pilot holes appropriate for the proper hardware
(sold separately), described under Specifications
on page 5, at the marked locations.
4. Align mounting holes with pilot holes, then
secure the Base with the hardware.
Mounting
Holes
Mounting
Stop
Mounting
Surface
Figure A
Attaching the Vise
1. Slide the bolt on the bottom of the Vise assembly
through the hole on the Base. Secure from
underneath with the Angle Adjustment Knob.
Vise
Assembly
Bolt
Angle
Adjustment
Knob
Figure B
2. Remove the Clamp Lock Nut
from the Vise Cable
3. Push the Vise Cable through the hole in the
Clamp Plate and secure with Clamp Lock Nut.
Clamp
Lock Nut
Vise
Cable
Clamp
plate
Figure C
