Page 12
For technical questions, please call 1-800-444-3353.
Item 61687
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Depth Adjustment
The Depth Adjustment Knob controls the
depth of the cut for each pass.
• Turn the Knob so that desired setting
on the Depth Gauge lines up with the
triangle marker on the Front Cover.
• Turn the knob back to the “0” marking
after the planer is used.
Fence Adjustment
The Fence controls the width of the cut
from the edge of the workpiece.
1. Insert the Knob (31) through the upper hole in
the Angle Bracket (60) and thread it into the
hole in the Left Housing. See
Figure H
.
2. Loosen the Wing Nut (61) and slide
the Fence to the desired setting.
3.
IMpORTANT:
Retighten the Wing
Nut after adjustment.
Note:
The markings on the Fence are intended
as general guidelines only. For accurate
measurements, use a measuring tool to verify
the position of the Fence after tightening.
Knob
(31)
Fence
(59)
Wing
Nut
(61)
Angle
Bracket
(60)
Figure H: Fence Assembly
Attaching the Dust Bag
Slip the open end of the Dust Bag (63) around
the open end of the Dust Chute (10).
Note:
You can install the Dust Bag
on either side of the Planer:
1. If installed, remove the Dust Bag
from the Dust Chute.
2. Press the Dust Chute Latch (11) and slide
the Dust Chute out of the Planer body.
3. Insert the Dust Chute all the way into the
opening on the opposite side of the Planer
body so that the Latch snaps into place.
4. Slip the open end of the Dust Bag over
the open end of the Dust Chute.
Содержание 61687
Страница 1: ......
