6 AWG GROUND WIRE
(NOT INCLUDED)
GROUND ROD
(NOT INCLUDED)
EARTH
CONCRETE SLAB
WING NUT (#43)
FIGURE C
OPERATING INSTRUCTIONS
NOTE: For additional references to the parts listed below, refer to the Assembly
Diagram on page 15.
Pre-Start Checks:
1.
NOTE: During operation, it may be necessary to refer to the
Engine
manufacturer’s Operation, Maintenance, and Parts manual (included) for detailed
information regarding the Engine.
2.
Check to make sure the Engine’s “ON/OFF” Switch is in its “OFF” position.
(See Figure D, next page.)
3.
Unscrew and remove the Engine’s Oil Fill Cap located at the bottom of the En-
gine Crankcase. Check to make sure the oil level is even with the top of the Oil
Fill Hole. If necessary, add oil until its level is even with the Oil Fill Hole. Then,
screw the Oil Fill Cap back onto the Oil Fill Hole. NOTE: Check with the Engine
manufacturer’s manual for the proper type of engine oil required for use.
(See Figure E, next page.)
4.
Check the Fuel Gauge (part #34) for the amount of unleaded gasoline in the Fuel
Tank (part #32). If necessary, remove the Fuel Tank Cap (part #37) and refill the
Fuel Tank with unleaded gasoline. Then, replace the Fuel Tank Cap. (See
Figure F, page 12.)
SKU 54206
PAGE 10