Page 5
SKU 40765
For technical questions, please call 1-800-444-3353.
MOunting
note:
The Hoist is delivered completely assembled. It must only be mounted for use.
Figure 1. Mounting the Hoist.
Figure 2. Optional Pole Mount.
The hoist may be mounted on a fixed overhead pipe, or attached to a pole on a rotating
pillar.
to attach your hoist to an overhead pipe using the included brackets.
Find the 2 Brackets/Fixing Rings (#3) and the Bolts/Hexagon Screws (#4).
1.
Place the Fixing Rings over a suitable pipe, in the position you wish to mount the hoist.
2.
Have an assistant hold the hoist in place while you install the Bolts through the Fixing
3.
Rings into the threaded holes in the Fixing Rack (#1) of the hoist.
With the hoist in the correct position, firmly tighten the bolts.
4.
uSing YOur HOiSt
The cable spool will not turn freely. To pull out or wind up cable, you must operate the
1.
power switch.
To operate the power switch, take the control handle in your hand. Press the upper part
2.
of the rocker switch to reel in the cable. Press the lower part of the rocker cable to reel
out cable.
Check to be sure it is safe to lift or pull the item.
3.
To pull out the cable, grasp the lift hook, and pull it away from the hoist while pressing
4.
the lower part of the power switch . Always leave at least three turns of cable on the
spool to prevent pulling the cable out of the Hoist.
Attach the cable firmly to the item using the lift hook or pulley lift hook. Never wrap the
5.
cable around the object and hook onto the cable itself. This can cause damage to the
object being pulled, and kink or fray the cable.
Stand clear, and when it is safe to do so, use the power switch in the control handle to
6.
retract the cable, and hoist the item as desired.
rEV 01j,02a
Brought to You by www.snapwhole.com
