SKU 38648
For technical questions, please call 1-800-444-3353.
Page 8
Adjusting Cutter Depth
The jointer should be pre-set at the factory
for the included biscuits. The depth of the
cut should be one half the width of the bis-
cuits you are using. If further adjustment
is necessary, proceed as follows.
note: Any change made will affect all 3
preset positions.
unplug the joiner.
1.
Position the preset dial to the biscuit
2.
size you are adjusting.
Turn the joiner upside down, bracing
3.
the handle against a solid surface.
Grasp the front of the base plate, and
4.
pull rearward until it stops.
Rotate the exposed blade so that one
5.
carbide tip is at maximum travel from
the face of the base plate.
Figure d
6. Use a small scale to measure this
distance, then turn Depth Adjustment
Dial (48) adjusting screw as needed.
The amount of exposed cutter should
be one half of the biscuit width.
(see Figure d.)
To Change The Cutting Blade:
unplug the joiner.
1.
Figure e
Figure F
2. Turn the Biscuit Joiner upside down
and remove both Allen Screws (67)
on the Adjustable Fence (64), using
the Hex Wrench provided. Remove
the Adjustable Fence by sliding it for-
ward.
(see Figures e and F.)
rev 02e
